1. Turn on Bluetooth of your iPhone.
2. Purchase linkage function of DigSpice III from in-app store.
3. Set the power switch of your DigSpice III to "BLE".
4. Tap the setting button in the bottom right corner of the camera screen.
5. Tap the "Selecting DigSpice".
6. Select the your DigSpice III named "DS3XXXXXXXX".
7. "DigSpice" will be displayed on the top of screen after the connection.
* DigSpice III can't be connected if the DigSpice III is already connected to other apps.
How to connect DriveMate d-OBD (DX501) to the app?
1. Turn on Bluetooth of your iPhone.
2. Purchase linkage function of DriveMate d-OBD (free) from in-app store.
3. Go to camera screen.
4. Start the engine.
5. It takes about 30 seconds to establish the connection.
6. "OBD" will be displayed on the top of screen after the connection.
* Setup is needed before using DriveMate d-OBD product. Please read the instruction manual below.
DriveMate d-OBD user's manual (written in Japanese):https://www.drivemate.jp/c/support/manual/DX501_manual.pdf
DriveMate Ecorda app (free) is needed for the setup. Please download from the link below.
Download DriveMate Ecorda from App Store: https://itunes.apple.com/jp/app/id920705463/
* DriveMate d-OBD is available and for use only in Japan.
How to connect ELM327 device to the app?
1. Purchase linkage function of ELM327 device from in-app store.
2. Plug the ELM327 device to your car.
3. Turn on Wi-Fi of your iPhone and connect to your ELM327 device.
4. Go to camera screen.
5. Start the engine.
6. It takes about 30 seconds to establish the connection.
7. "OBD" will be displayed on the top of screen after the connection.
* There are some cars might not be able to get data by the app.
Please check that your ELM327 device can be used with the app by "Test Connection" before purchase.
How to Edit Movie ?
You have to tap the middle button at the bottom in the playback screen. You can trim and add gauges.
How to move Gauges ?
In an environment where position information acquisition cannot be obtained, there is a meter that does not move. Also, you have to enable your mobile location services or GPS function.
